11.1. REAR PART

1. Drill 5 holes in the rear shell, make sure they are spread evenly and drill with 5,5mm.
2. Stick the rubber sealing strip to the underside of the rear shell
3. Clamp the rubber strip onto the front side of the rear shell, make sure the ends are in line with the body and extend about 1 centimetre over the t-bar as shown on the pictures. In the profile are metal clips, if they stick out, pull them out with pointed pliers, otherwise they will scratch the polyester.
4. Position the frame inside the rear shell using a few clamps and drill the top holes using a 6,5mm drill. Fasten with the M6x12 hex bolt.
5. Drill the other 4 holes from the inside to the outside using a 3mm drill. (be careful for the thread!) Then use a 4mm drill and mount the frame using the M4x10 hex bolts.
6. Mount the T-bar under the M6 bolts.
7. Place the rear shell and T-bar on the car, at the rear the shell rests on the body, at the front the lip on the T-bar slides in the windscreen. Fasten it using the short hexbolt. A piece of self-adhesive rubber seals the connection to the windscreen.
Do not drill the holes in the body yet!
8. Mount the 2 eccentrics using the M6x12 bolts.