|
When you fit a high windscreen you are obligated to fit a windscreen washer system. Burton Car Company supplies a universal washer system which suits a Burton perfectly. This system is easily fitted.
The washer system contains the following pieces: a reservoir with a pump, washer yet, push button, a piece of hose and a couple of wires and connectors.
Drill a Ø 8 mm hole through the body in the middle of the windscreen (check the diameter of the washer yet!! There are different types sold in the past). Make sure you drill the hole as far as possible from the windscreen. But keep in mind you do not hit any instruments or wires. When you do not have enough space underneath the dash you can also fit the washer yet in the bonnet.
Use the nut to secure the washer yet.
Remove the bracket of the reservoir and fit it to the bulkhead where you like. We chose to fit the washer reservoir on left and the blower on the right so you keep some free space in the middle to fit a spare wheel. Draw the holes on the bulkhead using the bracket as a mould. Drill 4,5 mm diameter holes and secure the bracket with two M4 bolts with washers. Slide the reservoir on to the bracket
Chose a nice spot to fit the washer push button and drill a hole in the dashboard of Ø 21 mm (check your button for the correct diameter. Different types of buttons are sold in the past).
In chapter 6 you can read how we describe how you can connect the washer system to the cable harness.
Fit the hose on to the washer jet and connect it to the pump. You can adjust the washer by putting a needle in the opening and move it to the correct position. Take in mind the wind effects the washer yet.
An extra cable set with connectors is supplied with the cable harness so you can be able to fit the washer pump and the blower. The connections are as followed:
>91 windscreen washer pump
>311 ground
|
Nederlands
English
Deutsch
Français
