7.4. FUEL FILLER PIPE

Mounting the stainless steel fuel-fillerpipe

-     Put the fuel filler pipe from the outside through the rear fender.<
-     Make sure that the filler pipe fits easily in the rubber sleeve (don’t forget to mount the sleeve with the clamps)
-     The bottom of the flange needs to touch the surface of the fender everywhere. If this is not the case you then need to do the following:  

* Sand of the curved side of the polyester
* Change the angle of the filler pipe
* Check if the filler pipe doesn’t clash with the polyester when it goes through the hole in the body. Also check if there is no tension in the pipe when it’s fitted.

-      Now start drilling the holes for the fixings use the filler pipe as a mold. (make sure nothing falls in to the tank.
-      Fit the fuel filler cap (in the following order: cap, gasket, fuel filler pipe and then the polyester fender) with the nuts and bolts that came with the cap. Make sure the cap is nicely flush with the fender.
-      Use two hose clamps to secure the rubber sleeve around the tank and filler pipe. Please make sure the hose clamps do not clash with the brake line.

RELATED PARTS

>>Fuel filler set

>>Filler cap TT

>>Fuel pipe (Stainless)

>>Rubber sleeve between filler neck and plastic fuel tank.

>>Hoseclamp 50/70 Stainess steel

>>Hoseclamp 40/60 stainless steel carburator small, tankfilltube small