5. MOUNTING THE BODY

5.1. Transport and storage

5.2. Properties of polyester

5.3. Working with polyester

5.4. Cleaning and polishing

5.5. Mounting the rear mudguards

5.6. Gluing the gaiter for the steering column in place

5.7. Pedals

5.8. The short legs kit

5.9. Heater connection

5.10. Vehicle Identification Plate from the donor car

5.11. Rear lights

5.12. Wiring harness

5.13. Battery tray and horn

5.14. Bootlid

5.15. Bootlid stand

5.16. The Bootlid lock and numberplate light

<<Back

Print | Print (incl. sub-chapters)

5.13. BATTERY TRAY AND HORN

Fit the battery bay to the right hand side of the bulkhead using three M6x20 bolts in the pre-drilled holes.

The middle bolt also carries the 2CV horn, however if you decide to apply the special two-tone Burton horn, the two outer bolts are used. The stud carrying the battery bay cannot be installed until the body is fitted onto the chassis.

RELATED PARTS

>>Scuttle set

>>Battery tray (INOX)