2.9. PARTSLIST

There are many parts directly transferable from the donor car to the Burton. A missing wing on the donor car is not a showstopper because you will not need any of the four on your Burton. However, do make sure that the following parts are included in you donor car and that they are in reasonable condition. Otherwise, you will have to find a replacement or buy them separately:

·         Chassis (with original number)

·         Citroen ID plate as can be found on the bulkhead.

·         License plates and papers

·         Chassis clips (the M7 ones used to fasten the body to the chassis)

·         Spring canisters and their fittings

·         Shock absorbers and their fittings

·         Engine and gear box

·         Front- and rear axle suspension, including the end rubbers

·         Rear seat

·         Battery

·         Complete windscreen wiper system

·         Complete handbrake (park brake) system

·         Brake- and fuel lines

·         Heater command stuff, including cables and fixtures

·         All pedals and master brake cylinder including brake fluid reservoir.

·         Bonnet stay

·         Heating tubes under the bonnet

·         Heat sink tubes plus their rubber grommets

·         Horn

·         Ignition coil plus its mounting brackets

·         Petrol tank plus bracket between tank and body, the so called “saddle”

Be sure to save all nuts and bolts of the donor car, washers, clips etc. many of these have oddball sizes (M7, M9) and/or strength (10.9 and 12.9) which can be extremely difficult to find and if found, they may be very, very expensive.

Optionally:

·         Seatbelts from the front seats

·         Wheels, tyres and the spare wheel

·         Speedometer/odometer

·         Exhaust

·         Headlights and indicator lights at the front

·         Flapping window frames plus its hinges from the front doors , which are re-used if you go for the Burton hard top option with the “gull wings”

Switches and handles from the dashboard