|
For dismounting a 2CV or something similar, you do not need very many special tools. Still, some tasks are a lot easier if you have the right equipment.
- Cap 44, hub/wheel bearing wrench
This cap (size 44) is used to unscrew the hub bolts (rear) and the wheel bearing bolts (front and rear). This cap is a special tool for the 2CV / Dyane / Mehari, developed and produced by Burton Car Company. For loosening the hub bolts, the magnetic rod should be removed, but this rod does need to be used for loosening the wheel bearing bolts.
Watch an instruction video made for this article here.
- Support arm wrench
With this wrench you can remove bolts that keep the support arms on the axles.
- Track rod wrench
The steering ball joint house contain a bolt with 4 notches that keep the ball bearings of the steering ball joint arms in position. This wrench fits exactly on these notches.
- Spanner 46
This spanner is used to remove the hex nuts from the suspension tube centre bus.
- Crank tool
This special tool is used to adjust the cranks of the rear brakes and hand brakes (front) of an A-type. The tool is thin so that you have enough space to place a spanner on the bolt.
- Cap 14 for fan
To remove the fan in order to get access to, among other things, the ignition and the fan belt.
- Cap 26 for the shock absorber bolt
This extra-long cap 26 is used to dismount the shock absorber bolt.
- Torque wrenches
To fasten the bolt and nuts sufficiently well.
Furthermore, the following tools are for sale for constructing the Burton:
- Hole-saw set for the instruments
In order to drill holes for several instruments, you need a hole-saw set. This set consists of a drill holder, a hole saw 52 mm and a hole saw 79 mm. Suitable for a Burton clocks set as well as for an MMB.
|
Nederlands
English
Deutsch
Français
